Desktop Installation; Rack Mounting - Planet FGSW-2620 User Manual

2.2.1 Desktop Installation

To install a Switch on a desktop or shelf, simply complete the following steps:
Step1: Attach the rubber feet to the recessed areas on the bottom of the Switch.
Step2: Place the Switch on a desktop or shelf near an AC power source.
Step3: Keep enough ventilation space between the Switch and the surrounding objects.
When choosing a location, please keep in mind the environmental

Note:
restrictions discussed in Chapter 1, Section 4, Specification.
Step4: Connect your Switch to network devices
A. Connect one end of a standard network cable to the 10/100 RJ-45 ports on the
front of the Switch.
B. Connect the other end of the cable to the network devices such as printer
servers, workstations or routers...etc.
Connection to the Switch requires UTP Category 5 network cabling with

RJ-45 tips. For more information, please see the Cabling Specification
Note:
in Appendix A.
Step5: Supply power to the Switch.
A. Connect one end of the power cable to the Switch.
B. Connect the power plug of the power cable to a standard wall outlet then power
on the Switch.
When the Switch receives power, the Power LED should remain solid Green.

2.2.2 Rack Mounting

To install the Switch in a 19-inch standard rack, follow the instructions described below.
Step1: Place your Switch on a hard flat surface, with the front panel positioned towards
your front side.
Step2: Attach a rack-mount bracket to each side of the Switch with supplied screws
attached to the package. Figure 2-3 shows how to attach brackets to one side of
the Switch.
Figure 2-3 Attaching the brackets to the Switch
5