Table of Contents
Advertisement
3. Installation
3.1 Desktop Installation
To install the PoE Ethernet Switch on desktop, simply follow the following steps:
Step 1: Attach the rubber feet to the recessed areas on the bottom of the PoE
Ethernet Switch, as shown in Figure 3-1.
Figure 3-1: Place the PoE Ethernet Switch on the Desktop
Step 2: Place the PoE Ethernet Switch on desktop near an AC power source.
Step 3: Keep enough ventilation space between the PoE Ethernet Switch and the
surrounding objects.
When choosing a location, please keep in mind the environmental
restrictions discussed in Chapter 1, Section 4 under Specifications.
Note
Step 4: Connect your PoE Ethernet Switch to 802.3af / 802.3at complied Powered
Devices (PD) and other network devices.
A. Connect one end of a standard network cable to the 10/100/1000 RJ-45
ports on the front panel of the PoE Ethernet Switch.
B. Connect the other end of the cable to the network devices such as printer
servers, workstations, router, etc.
Connection to the PoE Ethernet Switch requires UTP Category
6/5e/5 network cabling with RJ-45 tips. For more information,
please see the Cabling Specifications in Appendix A.
Note
11
Advertisement
Table of Contents
