Fgsw-2620 Rear Panel; Installing A Fgsw-2620 - Planet FGSW-2620 User Manual

Per 10/100/1000Base-T port
LED Color
LNK/ACT
Green
1000
LNK/ACT
Green
100
FDX Green

2.1.4 FGSW-2620 Rear Panel

The rear panel of the Switch indicates an AC inlet power socket, which accepts input
power from 100 to 240VAC, 50-60Hz. Figure 2-2 shows Rear panel of the Switch.
1. The device is a power-required device, it means, it will not work till it
is powered. If your networks should active all the time, please consider
using UPS (Uninterrupted Power Supply) for your device. It will prevent

you from network data loss or network downtime.
2. In some area, installing a surge suppression device may also
PowerNotice
help to protect your Switch from being damaged by unregulated
surge or current to the Switch or the power adapter.

2.2 Installing a FGSW-2620

This part describes how to install your Ethernet Switch and make connections to the
Switch. Please read the following topics and perform the procedures in the order being
presented.
To install your Switch on a desktop or shelf, simply complete the following steps.
4
Function
Lit: indicate that the port is operating at 1000Mbps.
Off: indicate that the port is operating at 10Mbps or 100Mbps.
Blink: indicate that the switch is actively sending or receiving
data over that port.
Lit: indicate that the port is operating at 100Mbps.
Off: indicate that the port is operating at 10Mbps or 1000Mbps.
Blink: indicate that the switch is actively sending or receiving
data over that port.
Lit: indicate that the port is operating at full-duplex mode.
Off: indicate that the port is operating at half-duplex mode.
Figure 2-2 Rear Panel of FGSW-2620