Connect Vent System - Jenn-Air 30" WALL-MOUNT CANOPY RANGE HOOD Installation Instructions And Use & Care Manual

3. Remove the metal grease filter and secure the blower
housing with two screws in the bottom holes located in the
rear of the blower.
A. Rear of blower housing
B. Bottom 5 x 45 mm screw holes
Glass Mantle Installation
1. Place the glass mantle onto the hood.
2. Connect glass mantle to range hood with the 2 glass
mounting brackets and four 4 x 8 mm screws.
C
B
B
A. Glass mantle
B. Glass mounting bracket
C. 4 x 8 mm screws
1. Fit vent system over transition piece.
2. Seal connection with clamps.
3. Check that backdraft dampers work properly.
1. Assemble the 3 parts of the deflector with 2 - 3.5 x 9.5 mm
2. Connect the deflector to the vent cover bracket using 4 - 3.5
B
A
3. Measure the length of 8" (20.3 cm) round vent (not provided)
4. Install vent between the transition and the deflector.
5. Seal connection with clamps.
6. Check that backdraft dampers work properly.

Connect Vent System

Vented Installation Only
For Non-vented (Recirculating) Installation:
screws provided. The assembled deflector should be sized to
fit the width of the vent cover bracket installed earlier.
C
A. Vent cover bracket width
B. Deflector
C. 3.5 x 9.5 mm screws
x 9.5 mm screws provided.
A. Vent cover bracket
B. 3.5 x 9.5 mm screws
needed to connect the transition to the deflector.
NOTE: Vent should fit inside deflector a minimum of
1" (2.5 cm)
A
B
A
B
9