Install Range Hood; Connect Vent System - Jenn-Air WALL-MOUNT CANOPY RANGE HOOD Installation Instructions And Use & Care Manual

Non-Vented (recirculating) Installations
1. Connect the deflector to the vent cover bracket using 4 - 3.5
x 9.5 sheet metal screws provided.
A. Vent cover bracket
B. C3.5 x 9.5 mm sheet metal screws
Complete Preparation
1. Determine and make all necessary cuts in the wall for the vent
system. Install the vent system before installing the hood. See
"Venting Requirements" section.
2. Determine the required height for the home power supply
cable and drill a 1¼" (3.2 cm) hole at this location.
3. Run wire through the home power supply cable according to
the National Electrical Code or CSA Standards and local
codes and ordinances. There must be enough ½" conduit
and wires from the fused disconnect (or circuit breaker) box
to make the connection in the hood's electrical terminal box.
NOTE: Do not reconnect power until installation is complete.
4. Use caulk to seal all openings.
8
A
1. Using 2 or more people, hang range hood on 2 mounting
B
2. Level the hood with leveling screws in mounting hooks or
3. Secure hood with 4 screws through remaining 4 holes in
1. Install transition on top of range hood (if removed for

Install Range Hood

WARNING
Excessive Weight Hazard
Use two or more people to move and install
range hood.
Failure to do so can result in back or other injury.
hooks through the rectangular cutouts on back of hood.
A
D
B
A. Mounting hooks
B. 5 x 35 mm mounting screws
rectangular cutouts, using a level across bottom of hood.
hood.

Connect Vent System

shipping) with 4 - 3.5 x 9.5 mm sheet metal screws.
B
A
A. Vent transition
B. 3.5 x 9.5 mm screw
B
C
C. Leveling screws
D. Centerline on wall
B