Table of Contents
Advertisement
OM20 Universal Outdoor Modem
1. Turn off power to the OM-20.
2. Install the Reset mating connector on J2 port.
3. Turn on power to the OM-20 and allow it to run for 2 minutes.
4. Turn off power to OM-20 and remover the Reset mating connector from J2.
5. The IP addresses of the OM-20 are now configured to the following:
6. In order for the computer to recognize the modem, the computers subnet Mask must match the
Subnet Mask of the modem. The IP Address Mask is 255.255.255.000. To ensure the safety of
the network, it may be necessary to contact the network administrator.
7. Turn on the unit. The unit is now ready to connect to the computer. Connect the RJ45 cable
from the OM-20 to the computer/router/bridge as illustrated in Figure 1.
8. Initiate PING test to ensure there is communication between the modem and the computer
Example: ping 192.168.0.238
If everything is functioning correctly, replies from the modem will appear on the computer
screen along with the time it took to respond. If unsuccessful, verify the following:
MN-OM20– Revision 5
Boot Modes:
Bootp Server Tag:
IP Address Mask:
Modem IP Address:
Server IP Address:
Router IP Address:
Figure 1. Ethernet Connection
IPTEST
206
255.255.255.000
192.168.0.238
192.168.000.101
192.168.000.102
Appendix D
D–2
Advertisement
Table of Contents
