Radyne OM20 Installation And Operation Manual page 112

Universal outdoor modem
Hide thumbs Also See for OM20:
Table of Contents

Advertisement

OM20 Universal Outdoor Modem
SCT Clock Source:
SCT Clock Polarity:
Esc Ch. 1 Gain
Esc Ch. 2 Gain
Eth Flow Control:
Eth Daisy Chain:
ETH QOS Type
ETH QOS Queue
TX ASYNC
Async Mode:
ES Interface:
MN-OM20– Revision 5
{SCT, SCR}
Allows the user to select SCT Source. SCT is the internally
generated SCT clock. SCR is the Rx Satellite clock. SCR us used
for loop timing.
{AUTO, NORMAL, INVERTED}
Allows the user to select the Clock Polarity for the SCT Clock
relative to the Tx Data. "Auto" detects wrong polarity and
automatically corrects. If G.703 Interface is selected, this
selection cannot be changed.
Provides gain in channel 1of engineering service channel in 96K
framing mode.
Provides gain in channel 2 of engineering service channel in 96K
framing mode.
{Disabled, Enabled}
Allows the user to disable or enable flow control. Only visible
when Ethernet is selected as the interface type.
{Disabled, Port 4}
Allows the user to disable the Ethernet Port Daisy Chaining or
enable it on Port 4. Only visible when Ethernet is selected as the
interface type.
{NORMAL, PORT BASED}
Selects the standard DMD20 priority hierarchy of processing an
IEEE 803.3ac Tag, Ipv4 Type of Service Field / Differentiated
Services Field, or Ipv6 Traffic Class Field. The Port Based
priority overrides any standard priority. When operating in this
mode, Port 1 (JS1) has the highest priority and Port 4 (JS4) has
the lowest.
{FAIR WEIGHTED, STRICT PRIORITY}
Selects the standard DMD20 queue weighting of 8,4,2,1 that
insures even the lowest priority traffic gets some bandwidth.
Strict Priority insures that the higher priority traffic will always
be transmitted before any lower priority traffic. With this setting,
the lower priority traffic can starve.
{ES-ES, ESC ENHANCED}
ES-ES is the normal IBS Async Channel. ESC Enhanced can be
selected in Closed Net and uses the Overhead Signaling bytes in
the IBS Overhead to pass asynchronous data. This menu is not
available when SCC is selected.
{RS-232, RS-485}
Allows the user to select the interface type.
Web Browser/Remote Protocol
6–38

Advertisement

Table of Contents
loading

Table of Contents