Table of Contents
Advertisement
OM20 Universal Outdoor Modem
The Control Ratio of the receiving units must match the Control Ratio of the transmitting unit.
4.16.2 Aggregate Data Rate
The aggregate data rate equals the following:
User Data Rate + In-Band Rate + Synchronizing Overhead Rate
Because SCC must adjust the overhead so that there are an equal number of user data bits in each
slot, the synchronizing overhead cannot be easily calculated. However, dividing the In-Band Rate
by the Control Ratio can approximate it. The following equation shows the basic calculation of
this rate:
Aggregate Date Rate = User Data Rate + In-Band Rate + (In-Band Rate/Control Ratio)
User Data
As an example, given the following parameters:
User Data Rate:
In-Band Rate:
Control Ratio:
Aggregate data rate = 1,024,000 + 19,200 + (19,200/7) or approximately 1,045,942
(actually 1045974).
This gives an overhead ratio of 1,045,974/1,024,000 = 1.021
In addition, another constraint changes the actual Aggregate Data Rate. The user data slot size
is limited to 2,500 bits. Because of this, the modem increases the in-band rate to reduce the user
data slot size. This only happens at higher user data rates.
MN-OM20– Revision 5
Figure 4-10. 1 to 1 Control Ratio diagram
Rate
Aggregate Data Rate
1,024,000 bps
19,200 bps
1 to 7
OM20 Theory of Operation
In-Band
Synchronizing
Rate
Overhead
4–23
Advertisement
Table of Contents
