Table of Contents
Advertisement
OM20 Universal Outdoor Modem
BUFFER CLOCK CONTROL
Buffer Size (msec):
Buffer Clock Polarity:
Number of Buffer Sources:
Active Buffer Clock:
BUFFER CLOCK SOURCES
Source 1 of 1:
Source 2:
Source 3:
Source 4:
Source 5:
RX ASYNC
Async Mode:
ES Interface:
ES Baud Rate:
MN-OM20– Revision 5
{0 - 64 msecs}
Allows the user to set the Doppler Buffer Size in msec.
{NORMAL, INVERTED}
Allows the user to select the Buffer Clock Polarity for the Tx
Terrestrial Clock relative to the Tx Data. If G.703 Interface is
selected, this selection cannot be changed.
{1 – 5}
Allows the user to select up to 5 clock sources.
{RXSAT, EXTBNC, SCTE, SCT, EXT IDI}
Shows the current active buffer clock source.
{SCTE, SCE, RX SAT, EXT BNC, EXT IDI}
{SCTE, SCE, RX SAT, EXT BNC, EXT IDI}
{SCTE, SCE, RX SAT, EXT BNC, EXT IDI}
{SCTE, SCE, RX SAT, EXT BNC, EXT IDI}
{SCTE, SCE, RX SAT, EXT BNC, EXT IDI}
{ES-ES, ESC ENHANCED}
ES-ES is displayed when IBS Network Spec is selected. ESC
Enhanced can be selected in Closed Net and uses the Overhead
Signaling bytes in the IBS Overhead to pass asynchronous data.
This menu is not available when SCC is selected.
{RS-232, RS-485}
Allows the user to select the interface type.
{150 – 1024} For IBS ES to ES
{150 – 19200} For ES to ES Enhanced
{150 – 115200} For SCC Communications
ES to ES : Fixed Baud Rate based on IBS Network
Specification. Available rates are listed in Table 3-3.
Web Browser/Remote Protocol
6–41
Advertisement
Table of Contents
