Table of Contents
Advertisement
OM20 Universal Outdoor Modem
Corrected BER:
Rx Buffer Level (Fill %):
Rx Bit Errors:
+1.5V TX Supply
+1.5V RX Supply
+3.3V Supply
+5V Supply
+12V Supply
-12V Supply
+20V Supply
LNB Current (Amps):
LNB Voltage (Volts):
BUC Current (Amps):
BUC Voltage (Volts):
MN-OM20– Revision 5
The CBER display shows an estimated corrected bit error rate of
the modem. Depending on the symbol rate the modem is
running, the high-end performance scale of this display will vary
-9
-10
-11
(10 E
, 10
or 10
). At some symbol rates, a better than scale
reading will appear as 0.0 x 10
appear as E**. In either case, they both mean performance is
better than the scale upper limit. This window continuously is
active and is above the Gel Tab area.
{0 – 100%}
Displays the status of the Doppler Buffer. This window is above
the Gel Tab area.
?
Displays the measured voltage of the 1.5 Volt Tx power bus
located inside the modem.
Displays the measured voltage of the 1.5 Volt Rx power bus
located inside the modem.
Displays the measured voltage of the +3.3 Volt power bus
located inside the modem.
Displays the measured voltage of the +5 Volt power bus located
inside the modem.
Displays the measured voltage of the +12 Volt power bus located
inside the modem.
Displays the measured voltage of the -12 Volt power bus located
inside the modem.
Displays the measured voltage of the +20 Volt power bus located
inside the modem.
Displays the measured current of the LNB
Displays the measured voltage of the LNB
Displays the measured current of the BUC
Displays the measured voltage of the BUCB
Web Browser/Remote Protocol
-00
. At other symbol rates, it will
6–45
Advertisement
Table of Contents
