emap function Configuration
E-map is use to show geographic area of homes, buildings,
region and etc. which includes locations of cameras layout
in the geographic region. E-map essentially provides geo-
graphic area with camera layouts monitored by SuperDVR
system in a form of a map. This feature is simple to use
and operates with direct status display and it is generally
graded or tiered in the form of a tree diagram.
To setup Emap select "emap" tab from the alarm Con-
figuration panel to enter E-map. Select the "auto-hide"
to enable E-map and configure the Holding time which
ranges from 5, 10, 15, 20, and 30 seconds. Holding time
is the time that E-map will display (pop-up) when an
event occurs until the event expired. To edit E-map simply
click on the "emap edit" button as illustrated below in
figure 43.
figure 43 - emap edit alarm Configuration
33 | SecurityMan
emap edit
Start by finding an ideal geographic picture(s) of the
region or building where SuperDVR is located. Save the
picture(s) file in a form bitmap (.bmp) or .jpg format into
a folder, i.e. "c:\superdvr". Be sure to jot down this geo-
graphic location "c:\superdvr" for easy retrieval when edit-
ing the emap edit.
figure 44 - e-map edit
Right-click on any part of the default virtual building to
select "Load Picture" as illustrated in figure 44 below.
Browse for the geographic picture i.e. c:\superdvr to select
the ideal picture region or building map. Then open the
picture file and the picture file will display in this interface