Motion Detection Record Mode; Recycling Record - SecurityMan iCamDVR User Manual

Motion Detection Record Mode

Motion detection will enable the system to detect the
changes in the image then activate motion detection,
motion alarm record, and begins to record. For example,
somebody open the door, the system then detects image
changes and begins to record, how opened the door can
be determined when playing back the recorded file. When
there is no movement, the system will not record saving
system resources, hard drive space, and convenient when
searching for event record file. The indicator light color in
the record status panel and Emap will show yellow
when motion is detected.
To setup Motion Detection Record Mode follows three
easy steps as follow:
• Select "Motion Detection" to enable motion detec-
tion per camera under the "Basic Configuration".
Each channel operates independent from one another.
"Schedule configuration" by setup the
• Configure the
days of the week, the time in a day, and the camera
channel for motion to be active.
• Finally, configure the motion detection areas and sen-
sitivity level for each camera(s) in the "Motion_Detec-
tion configuration"
19 | SecurityMan

Recycling Record

If Recycling Record function is enabled and all the optional
selected hard disk drives or partitions are full, the oldest
recorded data will be overwritten by the latest/current
recording data.
Storage Disk may vary depending on how many hard
drives or partitions are available in the system. The record-
ing storage disk will automatically advance to the next
partition when full. If all the selected drives/partitions are
LED full and recycle record mode are enabled, the new record-
ing data will overwrite the former recorded data automati-
cally. HDD minimum storage alarm can also be configured
in the alarm Configuration panel to alert when there are
limited amount of space available. Once the present stor-
age space is less than the configured minimum storage
and the recycle record mode is disabled; the recording will
automatically stop.