Table of Contents
Advertisement
Setting the Printer On and Off-line
Pressing the ON-LINE button switches the printer between the on-line (selected) and
off-line (deselected) modes. When the printer is on-line (READY lamp on), it is ready
to receive data and print. When the printer is off-line (READY lamp off), it cannot
receive data. All other buttons can only be activated when the printer is off-line.
Resetting the Printer
Pressing the
ends any printing operation and clears some error conditions. Data is retained in the
buffer and the printer is returned on-line.
The printer can be reset to user default settings by holding the Reset button for more
than two seconds when the printer is off-line. All temporary soft (downloaded) fonts/
macro data are deleted, the permanent soft (downloaded) fonts/macro data remain in
the printer until the power is turned off.
Manual Paper Feed and Paper Tray Selection
The TRAY TYPE sub-menu can be selected directly by pressing the TRAY TYPE
button for less than two seconds, while in the off-line mode.You can select Tray Feed
Mode and Manual Feed Mode using the menu selection procedure.
Tray 1 paper feed is the factory default setting.
You will see the following messages displayed in the window:
MANUAL FEED
OFF*
* indicates that this selection is the current default setting.
PAPER FEED
TRAY1*
* indicates that this selection is the current default setting.
AUTO TRAY SWITCH
OFF*
* indicates that this selection is the current default setting.
/Reset button for more than two seconds, while the printer is off-line,
(or ON)
MENU 1
(Press)
MENU 2
(TRAY2 if 2nd paper tray installed)
(FRONT FEEDER)
(ENVELOPE FEEDER if envelope feeder installed)
MENU 1
(Press)
MENU 2
(or ON)
Control Panel 1-3
Advertisement
Table of Contents
