Page 1
Warranty, Regulatory Information, and Specifications...
Page 2
OKI is a registered trademark of Oki Electric Industry necessarily constitute endorsement by Oki Data. Company, Ltd. OKICOLOR is a trademark of Oki Electric Industry Co., Ltd. Copyright Information Energy Star is a registered trademark of the United State Copyright 1999 by Oki Data. All Rights Reserved Environmental Protection Agency.
Energy Star .............. 4 Limited Warranty ............ 5 Limited Warranty—United States and Canada ....5 Limited Warranty—Latin America ......... 8 Oki Data Depot Service Centers ......9 Authorized Service Providers ......... 9 Important Safety Information ......11 Regulatory Information ........13 Specifications ............
As an Energy Star® Partner, Oki Data has determined that this All future products are committed to meeting the same Year product meets the Energy Star guidelines for energy 2000 compliance.
Oki Data will repair (or at its option, replace) at no charge, any defective component(s) of the Printer for one (1) year Oki Data will, for a period of one (1) year from the date of from the date of purchase except for the printheads (LED...
Page 6
THE RESPECTIVE WARRANTY PERIOD DESCRIBED ABOVE. Some states do not allow limitations on how long Oki Data will attempt to fix the problem over the telephone an implied warranty lasts, so the above limitation may not prior to scheduling an on-site visit. It will be the apply to you.
Page 7
Additional information on obtaining service under this Limited Warranty is available by contacting the OKI DATA dealer from whom the product was purchased, by contacting Oki Data directly at 1-800-654-3282 (1-800-OKI-DATA), United States and Canada, English and French only, or 1-856-222-5276 (Spanish only), or by contacting one of the listed service locations.
This Limited Warranty shall not apply if the product has been Oki Data will repair (or at its option, replace) at no charge, damaged due to abuse, misuse, misapplication, accident, or any defective component(s) of the Printer for one (1) year...
Phone: 800-654-3282 (800-OKI-DATA) Authorized Service Providers U.S. and Canada, English and French only +856-235-2600 (Latin America) Oki Data has over 2,000 local Authorized Service Providers Fax: 856-222-5247 (U.S. and Canada) in North and South America. 856-222-5260 (Latin America) For the most comprehensive, up-to-date listing of Oki Data...
Page 10
Oki Data do Brasil, Ltda. Av. Leonardo da Vinci, 1178/1182 Jabaquara Sao Paulo, Brazil Phone: 55-11-5011-1518 Fax: 55-11-5012-0267 Mexico Oki Data de Mexico, S.A. de C.V. Av. Insurgentes 1700 – 7 Piso Col. Florida 01030 Phone: (525) 661-6860 Fax: (525) 661-5861 OKICOLOR 8...
Important Safety Overview Information Your Oki Data printer has been carefully designed to give • Protect your printer from overheating. Make sure no you years of safe, reliable performance. As with all electrical obstructions block the openings of the printer. Do not put...
Page 12
• Do not make any adjustments other than those outlined in the documentation. You may cause damage that will require extensive repair work. The provided documentation explains how to get your printer serviced by qualified Oki Data technicians. OKICOLOR 8...
However, Changes or modifications not expressly approved by Oki there is no guarantee that interference will not occur in a Data may void your authority to operate this device.
Industry Canada Radio Interference Commission Radio Frequency Statement for 120-Volt Models Interference Statement for 230/240- This Oki Data apparatus complies with the Class B limits for Volt Models radio interference as specified in the Industry Canada Radio Interference Regulations. WARNING: This equipment has been tested and found to...
Page 15
Volt Models operation. 3. Responsible Party This product is in conformity with Directive 73/23/EEC on Oki Data Americas, Inc. the harmonization of the laws of Member States relating to 2000 Bishops Gate Boulevard electrical equipment designed for use within certain voltage limits.
Specifications Overview For additional specifications (including General, Physical, Interface, Print Media, Fonts, and Commands) refer to the on- line User’s Guide. Power Electrical Idle Approximately 70 W Voltage Operating 120 V: 120 VAC +5.5%, -15% Approximately 230 W 230 V: 230VAC +/- 10% Peak Frequency Approximately 980 W...
Page 17
Environmental Temperature Humidity Operating Operating Maximum Permissible Maximum Permissible 50 to 90° F 20 to 80% Relative Humidity 10 to 32° C Best Color Print Quality Best Color Print Quality 50 to 70% Relative Humidity 63 to 81° F Power Off 17 to 27°...
If person’s Revised September, 1999 breathing is difficult, give oxygen. For more information, contact Oki Data at: Toner gets in the eyes Flush eyes with large quantities of cool water for 15 minutes, 2000 Bishops Gate Blvd.
Hazardous Ingredients Fire and Explosion Hazard Data Carbon Black (4% by weight) Flash Point (Method Used): Not applicable CAS# 1333-86-4 Flammable Limits OSHA TWA 3.5 mg/m Lower Explosive Limit: Not known ACGIH TLV 3.5 mg/m Upper Explosive Limit: Not known Physical Data Extinguishing Media: CO , Dry Chemical, or Foam...
Health Hazard Data Reactivity Data Routes of Entry: Inhalation, Ingestion, Eyes, Skin. Stability: Stable 1 Carbon Black Polymerization: Will not occur. Group 2B “Possible Carcinogen”; IARC Hazardous Decomposition Products: Combustion or decomposition will generate phenol derivatives, carbon Evidence of development of lung tumors in rats receiving monoxide and carbon dioxide at temperatures over 300°C chronic inhalation exposure to free carbon black at levels (572°F).
Spill Cleanup and Disposal Safe Handling and Use Respiratory Protection: Not normally required. For large Spill Cleanup spills, use NIOSH/MSHA approved full face-piece Small Spills respirator with HEPA cartridge during cleanup. 1 Sweep up spill. Protective Gloves and/or Eye Protection: Not normally required.
Page 22
Special Precautions The information contained in this MSDS is based on data Precautions for Handling or Storage: Protect from high considered accurate; however, no warranty is expressed or heat. Store in a well-ventilated area at temperature below implied regarding the accuracy of these data or the results to 35°C (95°F) to prevent caking.
If person’s Revised September, 1999 breathing is difficult, give oxygen. For more information, contact Oki Data at: Toner gets in the eyes Flush eyes with large quantities of cool water for 15 minutes, 2000 Bishops Gate Blvd.
Hazardous Ingredients Fire and Explosion Hazard Data None, according to OSHA 29 CFR 1910.1200 and DOT 49 Flash Point (Method Used): Not applicable CFR 172.101. Flammable Limits Lower Explosive Limit: Not known Physical Data Upper Explosive Limit: Not known Melting Point: Not available Extinguishing Media: CO , Dry Chemical, or Foam Softening Point: 101 to 107°C (214 to 225°F)
Page 25
Reactivity Data Spill Cleanup and Disposal Stability: Stable Spill Cleanup Polymerization: Will not occur. Small Spills Hazardous Decomposition Products: Combustion or 1 Sweep up spill. decomposition will generate phenol derivatives, carbon Large Spills monoxide and carbon dioxide at temperatures over 300°C (572°F).
Page 26
Safe Handling and Use The information contained in this MSDS is based on data Respiratory Protection: Not normally required. For large considered accurate; however, no warranty is expressed or spills, use NIOSH/MSHA approved full face-piece implied regarding the accuracy of these data or the results to respirator with HEPA cartridge during cleanup.
Page 27
If person’s Revised September, 1999 breathing is difficult, give oxygen. For more information, contact Oki Data at: Toner gets in the eyes Flush eyes with large quantities of cool water for 15 minutes, 2000 Bishops Gate Blvd.
Page 28
Hazardous Ingredients Fire and Explosion Hazard Data None, according to OSHA 29 CFR 1910.1200 and DOT 49 Flash Point (Method Used): Not applicable CFR 172.101. Flammable Limits Lower Explosive Limit: Not known Physical Data Upper Explosive Limit: Not known Melting Point: Not available Extinguishing Media: CO , Dry Chemical, or Foam Softening Point: 101 to 107°C (214 to 225°F)
Page 29
Reactivity Data Spill Cleanup and Disposal Stability: Stable Spill Cleanup Polymerization: Will not occur. Small Spills Hazardous Decomposition Products: Combustion or 1 Sweep up spill. decomposition will generate phenol derivatives, carbon Large Spills monoxide and carbon dioxide at temperatures over 300°C (572°F).
Page 30
Safe Handling and Use The information contained in this MSDS is based on data Respiratory Protection: Not normally required. For large considered accurate; however, no warranty is expressed or spills, use NIOSH/MSHA approved full face-piece implied regarding the accuracy of these data or the results to respirator with HEPA cartridge during cleanup.
Page 31
If person’s Revised September, 1999 breathing is difficult, give oxygen. For more information, contact Oki Data at: Toner gets in the eyes Flush eyes with large quantities of cool water for 15 minutes, 2000 Bishops Gate Blvd.
Page 32
Hazardous Ingredients Fire and Explosion Hazard Data None, according to OSHA 29 CFR 1910.1200 and DOT 49 Flash Point (Method Used): Not applicable CFR 172.101. Flammable Limits Lower Explosive Limit: Not known Physical Data Upper Explosive Limit: Not known Melting Point: Not available Extinguishing Media: CO , Dry Chemical, or Foam Softening Point: 101 to 107°C (214 to 225°F)
Page 33
Reactivity Data Spill Cleanup and Disposal Stability: Stable Spill Cleanup Polymerization: Will not occur. Small Spills Hazardous Decomposition Products: Combustion or 1 Sweep up spill. decomposition will generate phenol derivatives, carbon Large Spills monoxide and carbon dioxide at temperatures over 300°C (572°F).
Page 34
Safe Handling and Use The information contained in this MSDS is based on data Respiratory Protection: Not normally required. For large considered accurate; however, no warranty is expressed or spills, use NIOSH/MSHA approved full face-piece implied regarding the accuracy of these data or the results to respirator with HEPA cartridge during cleanup.
Page 35
Wipe off with dry cloth or towel, then wash with detergent. Revised September, 1999 Oil swallowed (ingested) Wash mouth thoroughly with water. NEVER give anything by For more information, contact Oki Data at: mouth to a person who is unconscious. Seek medical 2000 Bishops Gate Blvd. attention immediately.
Page 36
Hazardous Ingredients Fire and Explosion Hazard Data None (silicone fluid). Flash Point (Method Used): 300°C (572°F) minimum (open cup) Physical Data Flammable Limits Melting Point: Not applicable Lower Explosive Limit: Not known Softening Point: Not applicable Upper Explosive Limit: Not known Boiling Point: Not applicable Extinguishing Media: CO , Dry Chemical, or Foam...
Page 37
Reactivity Data Safe Handling and Use Stability: Stable Respiratory Protection: Not normally required. This product can generate formaldehyde at approximately 150°C Polymerization: Will not occur. (300°F) and above in the presence of air: If product is Hazardous Decomposition Products: None. exposed to such high temperatures, respiratory protection Temperature: Not available.
Page 38
Special Precautions The information contained in this MSDS is based on data Precautions for Handling or Storage: Store in a cool place. considered accurate; however, no warranty is expressed or Protect from high heat. This product can generate implied regarding the accuracy of these data or the results to formaldehyde at approximately 150°C (300°F) and above be obtained from the use thereof.