Table of Contents
Advertisement
3.1 STATUS LED
The status LED, part 6 in figure 1, indicates the state of the SCA. The chart below describes the
state of the SCA and how the status LED indicates this.
Status LED
Green
Flashing Green
Off
Red
Table 2: Table over the status LED indication.
4 TROUBLE SHOOTING
Status LED
Off
Off
Red
Table 3: Trouble shooting guide.
4.1 RESET PORT
The SCA is also equipped with a Reset port, part 2 in figure 1, which can be used to perform a soft
reset or a factory reset. Reset is performed by short circuit the two holes in the reset port. Below
follows a description over the different reset procedures and how these are performed.
4.1.1
PREPARING FOR RESET
Find a piece of hard electric wire, a paper clip or a similar tool which will fit through the holes of the
reset port. Make sure the tool enters the two holes in a straight line to a depth of approximately 7
millimeters from the entrance point.
4.1.2
SOFT RESET
Performing a soft reset means resetting the SCA without restoring the settings of the adapter to the
default factory settings. To perform a soft reset, short circuit the reset port with e.g. a paper clip,
until the status LED starts flashing red. Immediately remove the short circuit before the status LED
stops flashing.
4.1.3
FACTORY RESET
Factory reset means the SCA restores the default factory settings of the adapter. To perform a
factory reset, short circuit the reset port with e.g. a paper clip, until the status LED starts flashing
red. Keep the short circuit active approximately ten seconds until the status LED stops flashing and
starts outputting a steady red light.
Page 5 of 16
SCA Status
Link has been established and OK.
Transferring data.
No link established or power off
Fatal Error.
Cause
No link.
No power to SCA.
Fatal error.
Corrective actions
Please check the connection of
the network cable.
Please check the connection of
the power line.
Please contact your dealer.
Hide quick links:
Advertisement
Table of Contents
