Table of Contents
Advertisement
6
Functions
6.1
LED Indications
LED indication
Green
Green/red flashing
Red
6.2
Information output signal attributes
The information output of the unit is set depending on the state of the internal safety loop
A/B:
Safety loops (A and B)
One or both safety loops open
Both safety loops closed
The delay for switching the information output signal:
Information output signal switch
Delay
Note!
Warning!
2TLC172125M0201 Rev.F
Description
DYNlink input signal, both safety
loops closed
DYNlink input open or 0 VDC,
both safety loops closed
One or both safety loops open
If any of the safety loops are open longer than 70 ms the information
output is set low for approximately 1.2 s. If any of the safety loops stay open
the information output stays low. If any of the safety loops are open for less
than 50 ms the information output will stay high.
Information output signals shall never be used for safety purpose(s).
DYNlink state
OK
Interrupted before this
unit
Interrupted in this unit
Information output
Low
High
High -> Low
~ 60 ms
Low -> High
~ 10 ms
10
Advertisement
Table of Contents
