ABB CCA-01 Quick Manual

Options for ABB drives, converters and inverters
Quick guide
CCA-01 communication adapter
CCA-01 communication adapter provides serial communication interface to
certain unpowered ABB drives frequency converters.
Safety instructions
Obey these safety instructions when using the communication adapter.
WARNING! Ignoring the following instructions can cause physical
injury or death or damage to the equipment.
Use the communication adapter only with an unpowered drive.
General
CCA-01 communication adapter provides safety isolation of both serial communication and control
board power supply. The power supply is taken from the USB port of a PC. The adapter can be used
with several ABB drives PC tools: software loading tools and commissioning tools.
USB cable
Use only the supplied USB cable. Connect both USB connectors to the PC to ensure sufficient
current supply to the adapter and drive control board.
USB drivers
The adapter uses the same USB drivers as ACS-AP-x control panel. See Drive composer start-up
and maintenance PC tool user's manual [3AUA0000094606 (English)] for installation instructions.
Indicator LEDs
LED indications
COMM (CCA-01 to drive communication)
Off
Blinking orange
DRIVE (drive power supply indication)
Off
Blinking green
Green
Red
POWER (CCA-01 USB power supply indication)
Off
Green
Blinking red
System state / explanation
No communication
Communication between PC tool and drive
Drive connected, but CCA-01 powering not succeeded
No drive connected (ready for connection)
Drive connected
Drive power supply is connected
Not powered
CCA-01 is powered from USB
CCA-01 is in fault state