Type Designation; Installation - ABB CEM 05100 User Manual

2.2 TYPE DESIGNATION

Below are tables with explanation for all positions in the type designation for the SCA.
Type
Basic
Serial Communication Adapters
Media
Power Line, Band A
Power Line, Band C
Ethernet
GSM/GPRS
RS 232
Twisted Pair
Protocol
LonWorks
M-Bus
Supply voltage
Powered by device
100 - 240 V
220 - 240 V
Optional functionality
No options
Functional upgrade
Table 1: Type designation of ABB Serial Communication Adapters.

3 INSTALLATION

1. Disconnect the power supply.
2. Strip the wires and connect them to the top terminals of the SCA.
3. Connect the Ethernet cable to the RJ-45 LAN interface of the SCA, which is located on the
bottom of the SCA.
4. Place the SCA to the left of the meter and snap it on the DIN-rail.
5. Verify that the SCA is correctly wired and the voltage is according to the technical
specification before the power is turned on.
6. Verify that the status LED is green to ensure power on and an active network link
Figure 2: Installation of the SCA
Page 4 of 16
Pos
1 2 3
C
A
C
E
G
R
T
L
M
.
4 5 6-8
0
4
5
6
000
100