Roof Panel - Arrow VM1012-B Owner's Manual & Assembly Instructions

Step 3
SV16
The roof beams join the two gables
and support the roof panels. The main
roof beam is made up of four pieces
overlapped back to back at the cen-
ter. The left and right roof beam as-
semblies are made up of two pieces.
Hint: These pieces are force-fitted,
so you may have to press hard to join
them together.
1
Place one end of a roof beam
inside another roof beam so that the
six holes in each piece align. Make
four sets of roof beams by repeating
this procedure. Do not insert bolts
yet.
2
Take two of the pressed-together
roof beams and join them as shown
to form the main roof beam assembly.
Hold the assembly together and fas-
ten with 14 bolts. Build only one
Doubled Beam Assembly.
3
Fasten the other two pressed-
together roof beams with eight bolts
to make the left and right roof beam
assemblies.
4
Set these pieces aside for later
assembly.
16
● Parts Needed For ●
Roof Beam Assemblies
10397
STEP
1
STEP
2
STEP
3
Build two Single Beam
Assemblies
Assembled
End
View
Build one Doubled Main Roof
Beam Assembly for Peak in Roof
142 3/8"
3,6m
● ● ● ● ● 10397 Roof Beam (8)
10397
142 3/8" 3,6m
142 3/8"
3,6m