Side Siding (6 Board) - Arrow VM1012-B Owner's Manual & Assembly Instructions

Step 9
SW22
Each screw in the wall requires a
washer.
1
Slide side siding (5 board) into
channels of corner and splice posts,
flat edge upward, bottom edge down
resting on floor frame. Always follow
this pattern. Fasten bottom edge and
tab of stud to floor frame using screws.
Fasten center to stud with screws.
Do not fasten flat edge yet.
2
Install side siding (3 board) as
before. Note how the slot in bottom
edge must overlap flat edge of last
siding. Fasten both siding panels to
stud at this overlap.
3
Install side siding (6 board) to the
top as before. Remove and reuse
screw in angle to fasten top siding.
4
From inside building, fasten siding
to corner posts using screws.
5
Repeat steps 1 through 4 for oppo-
site side of building.
NOTE
Be careful to install the correct
panel in each position as shown.
The floor frame must be square
and level or holes will not align.
22
● Parts Needed For ●
Side Siding
(6 board)
(3 board)
(5 board)
STEP
4
End
View
Bottom
Edge
Flat
Edge
Be certain all Siding
overlaps are fastened
with a single screw
● ● ● ● ● 6287 Side Siding (5 board) (4)
● ● ● ● ● 5335 Side Siding (3 board) (4)
● ● ● ● ● 5336 Side Siding (6 board) (4)
5336 (6 board)
5335 (3 board)
Washer
6287 (5 board)
THIS SCREW MUST
FASTEN TAB OF STUD
STEP
1
STEP
3
STEP
2
Remove
and
Reuse