Installing Or Removing A Memory Module - Lenovo ThinkServer TD330 Manual

Installing or removing a memory module

This topic provides instructions on how to install or remove a memory module.
Note: The memory modules are sensitive to ESD. Ensure that you read and understand "Handling
static-sensitive devices" on page 76 first and carefully perform the operation.
Memory module installation rules
Your server has 12 memory slots and it has the following features:
• Each slot supports 4 GB, 8 GB, and 16 GB 1333 MHz double data rate 3 low-voltage registered dual inline
memory modules (DDR3 LV RDIMMs).
• Each slot supports 4 GB, 8 GB, and 16 GB 1333 MHz DDR3 RDIMMs.
• Each slot supports 2 GB and 4 GB 1333 MHz DDR3 unbuffered dual inline memory modules (UDIMMs)
with Error Checking and Correcting (ECC) technology.
• Your server supports up to six memory modules when one microprocessor is installed and up to 12
memory modules when two microprocessors are installed.
• The minimum system memory for RDIMMs or LV RDIMMs is 4 GB (only one microprocessor installed and
only one 4 GB RDIMM or LV RDIMM installed in the CPU1 DIMMA1 slot).
• The minimum system memory for UDIMMs is 2 GB (only one microprocessor installed and only one 2
GB UDIMM installed in the CPU1 DIMMA1 slot).
• The maximum system memory for RDIMMs or LV RDIMMs is 192 GB (two microprocessors installed and
one 16 GB RDIMM or LV RDIMM installed in each of the 12 memory slots).
• The maximum system memory for UDIMMs is 48 GB (two microprocessors installed and one 4 GB
UDIMM installed in each of the 12 memory slots).
For more information about the memory modules in your specific server model, use the Setup Utility
program. See "Viewing information in the Setup Utility program" on page 53.
For a list of supported ThinkServer memory module options, go to:
http://www.lenovo.com/thinkserver
.
Chapter 6 Installing, removing, or replacing hardware
85