Lenovo ThinkServer TD330 Manual page 146

8. Install the new non-hot-swap hard disk drive into a blue bracket by flexing the sides of the bracket and
aligning pin 1 , pin
drive so that the hard disk drive can be seated in the bracket.
Note: Do not touch the circuit board
Figure 69. Installing the non-hot-swap hard disk drive into the bracket
9. Slide the new non-hot-swap hard disk drive with bracket into the drive bay until it snaps into position.
10. Connect the appropriate power cable
hard disk drive. See "Connecting the cables" on page 39.
Figure 70. Connecting cables to the rear of the non-hot-swap hard disk drive
11. Connect the other end of the SATA signal cable to the appropriate SATA connector on the system board.
See "System board components" on page 42 and "Connecting the cables" on page 39.
12. Reinstall the front system fan 1. See "Replacing the front system fan 1" on page 161.
132
ThinkServer TD330 Hardware Maintenance Manual
2 , pin 4 , and pin 5 on the bracket with the corresponding holes in the hard disk
3 on the bottom of the hard disk drive.
1 and the SATA signal cable 2 to the rear of the non-hot-swap