Lenovo ThinkServer TD330 Manual page 167

8. Lift the release latch
Note: The following illustration shows the 3.5-inch hard disk drive cage. For the 2.5-inch hard disk
drive cage, the removal procedure is the same.
Figure 91. Removing the hard disk drive cage
9. Depending on whether your server has a 2.5-inch hot-swap hard disk drive cage with backplane or
3.5-inch hot-swap hard disk drive cages with backplanes, do one of the following:
• For the 3.5-inch hot-swap hard disk drive backplane, remove the four screws that secure the
backplane, and then remove the backplane from the hard disk drive cage.
Figure 92. Removing the 3.5-inch hot-swap hard disk drive backplane
1 and slide the hard disk drive cage out of the front of the chassis.
.
Chapter 6 Installing, removing, or replacing hardware
153