Lenovo ThinkServer TD330 Manual page 92

This topic provides instructions on how to remove the server cover.
Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
Note: Depending on the model, your server might look slightly different from the illustrations in this topic.
To remove the server cover, do the following:
1. Remove all media from the drives. Then, turn off all attached devices and the server.
2. Disconnect all power cords from electrical outlets.
3. Disconnect the power cords, Input/Output (I/O) cables, and all other cables that are connected to
the server.
4. Remove any locking device that secures the server cover, such as a padlock or an integrated cable
lock. See "Server locks" on page 23.
5. Loosen the thumbscrew that secures the server cover, and then slide the server cover to the rear
until it is stopped.
Notes:
a. The server cover is securely installed and you need to use a tool, such as a screwdriver, to loosen
the thumbscrew that secures the server cover. The thumbscrew is an integrated part of the server
cover. Do not try to remove the thumbscrew from the server cover.
b. It is recommended that you wait three to five minutes to let the server cool before removing the
server cover.
Figure 29. Sliding the server cover to the rear
78
ThinkServer TD330 Hardware Maintenance Manual