Lenovo ThinkServer TD330 Manual page 119

• Use any documentation that comes with the TR 700 Battery and follow those instructions in addition to
the instructions in this topic.
To remove the TR 700 Battery, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. Remove the server cover. See "Removing the server cover" on page 77.
3. Lay the server on its side for easier operation.
4. If a PCI card bracket assembly is installed in your server, remove the PCI card bracket assembly. See
"Removing and reinstalling the PCI card bracket assembly" on page 81.
5. Locate the ThinkServer RAID 700 Adapter, which is located in the PCI-E slot 5 or PCI-E slot 6 on
the system board.
6. Remove the ThinkServer RAID 700 Adapter, which is a kind of RAID card. See "Installing or removing
the RAID card" on page 97.
7. Carefully remove the three screws that secure the TR 700 Battery, and then lift the TR 700 Battery up
from the ThinkServer RAID 700 Adapter.
Note: Center the screwdriver when you remove the screws to avoid possible damage to any parts.
Figure 49. Removing the TR 700 Battery
8. If you want to install a new TR 700 Battery, see "Installing the TR 700 Battery" on page 103.
9. Reinstall the ThinkServer RAID 700 Adapter with a new TR 700 Battery or without a TR 700 Battery. See
"Installing or removing the RAID card" on page 97.
10. Reinstall the PCI card bracket assembly. See "Removing and reinstalling the PCI card bracket
assembly" on page 81.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the removal procedure, go to "Completing the parts replacement" on page 178.
.
Chapter 6 Installing, removing, or replacing hardware
105