SOLE F63 Owner's Manual page 16

TREADBELT TRACKING ADJUSTMENT:
The performance of your treadmill is dependent on the frame running on a reasonably level
surface. If the frame is not level, the front and back roller cannot run parallel, and constant belt
adjustment may be necessary.
The treadmill is designed to keep the treadbelt reasonably centered while in use. It is normal
for some belts to drift near one side while the belt is running with no one on it. After a few
minutes of use, the treadbelt should have a tendency to center itself. If, during use, the belt
continues to move toward one side, adjustments are necessary.
TO SET TREADBELT TRACKING:
A 6 mm Allen wrench is provided to adjust the rear roller. Make tracking adjustments from the
left side only. Set belt speed at
approximately 2 to 3 mph. A small adjustment can
make a dramatic difference. Turn the bolt only a
1/4 turn and wait a few minutes for the belt to
adjust itself. Continue to make 1/4 turns until the
belt stabilizes in the center of the running deck.
The belt may require
periodic tracking adjustment depending on use
and walking/running characteristics. Some users
will affect tracking differently. Expect to make adjustments as required to center the treadbelt.
Adjustments will become less of a maintenance concern as the belt is used. Proper belt
tracking is an owner responsibility common with all treadmills.
ATTENTION:
DAMAGE TO THE RUNNING BELT RESULTING FROM IMPROPER TRACKING /
TENSION ADJUSTMENTS IS NOT COVERED UNDER THE SOLE WARRANTY.
BELT / DECK LUBRICATION:
Do not re-lube with other than Sole lubricant. Sole provides one application with this unit. See
your Sole dealer for additional purchases. The use of some other lubricants may destroy the
deck surface or belt and will void warranty. Conditions exist beyond Sole's control on belt /
deck cleanliness which relates to friction.
You should apply the enclosed belt lubrication after approximately the first 50 hours of operation.
Use all the contents of one container (no more) and spread lubricant onto middle portion (away
from edges) of the deck (under treadbelt) along it's width. When walked on, the belt will make
certain an even coat is applied. Lubricant is not harmful to the skin. Lube will be distributed
properly by walking at 2 to 3 mph for 3 to 5 minutes on all areas of the belt. Use handrails for
support. The first few minutes you will be polishing your deck and lubricating the belt backing.
Do not run on a newly lubricated belt until the above break-in procedure is done.
If the treadmill belt/deck is kept reasonably clean it is possible to expect over 1000 hours before
additional re-lubing is necessary.
CAUTION - KEEP HANDS CLEAR OF MOVING REAR PULLEY!
F63
-15-