Top Vent Adapter - Quadra-Fire SANTAFE-B1 Owner's Manual

R
B. Top Vent Adapter Installation
3 to 3 inch Top Vent Adapter
3 to 6 inch Top Vent Offset Adapter
Installing the Top Vent Adapter
1. Put a layer of high temperature silicone on the 
inch (76mm) exhaust outlet. Figure 18.1
2. Slide the top vent adapter onto the rear exhaust
outlet and adjust the assembly to a vertical position.
Figure 18.1
. Drill 4 holes with #26 drill bit (provided) into the
back of the appliance using the outer shield as
a pattern (make sure the assembly is vertical).
Figure 18.2
4. Install the 4 mounting screws.
5. Drill 2 holes with #26 drill bit through the rear
exhaust outlet using the 2 holes already in the short
horizontal pipe in the top vent adapter as a guide.
Install the 2 screws. Figure 18.1
6. Install the vent pipe into the top vent adapter (be
sure to silicone all joints).
7. To clean the top vent adapter open the clean-out
cover. Figure 18.2.
 to 6 in.
Offset
Adapter
 to  in.
Top Vent
Adapter
Use hole on each side as
drilling guide
Figure 18.1
Page 18
Silicone
Rear Exhaust
Outlet
Figure 18.2
C. Rear Vent and Rear Vent to Top Vent
Adapter Installation
Figure 18.3 - Rear Vent Adapter
Clean-Out Cover
Figure 18.4 - Rear to Top Vent Adapter - 90
1. Put a layer of high temperature silicone on the  inch
(76mm) exhaust outlet. Figure 18.1.
2. Slide the adapter onto the rear exhaust outlet and adjust
the assembly to the appropriate position.
. Install the vent pipe into the adapter (be sure to silicone
all joints)
7001-142D
Santa Fe Pellet Stove
Drill holes in back of
stove and secure
with 4 screws, 2 on
each side
Clean-Out Cover
Clean-Out Cover
September 1, 2008
o