Log Set Placement - Quadra-Fire SANTAFE-B1 Owner's Manual

R R
Santa Fe Pellet Stove
D. Optional Log Set Placement Instructions
CAUTION
Logs are FRAGILE. Use extreme care when handling or
cleaning logs.
NOTE:
Due to the abrasive nature of a pellet appliance fire, the
logs are not covered under warranty. Any placement varia-
tion other than shown here can cause excessive heat and
shall void the appliance warranty.
4 PIECE LOG SET INSTALLATION
1. Place the right rear log as shown. There is a notch in the
bottom of the log for clearance for the thermocouple and
thermocouple cover (ceramic protection tube). Figure
19.1.
2. Continue placing the last  logs around the firepot as
show in Figures 19.2, 19.3 and 19.4. Be careful not to
block the drop tube in the back of the firebox where pel-
lets feed into the firepot.
Notch
Thermocouple
Cover
Figure 19.1
Drop Tube
Figure 19.2
September 1, 2008
Figure 19.3
Figure 19.4
OPTIONAL TOP LOG
Place the top log over the firepot. It will be about
2-1/2 inches (64mm) above the firepot when in
place. Notice the position of the top log as it rests
on the  logs in a stable position to prevent it from
falling into the firepot.
The charred area on the back of the top log faces
the back, not the front. Figure 19.5.
Figure 19.5
7001-142D
R
Page 19