Top Vent Adapter; Rear Vent Adapter - Quadra-Fire MTVERNON-AE-MBK Owner's Manual & Installation

Mt. Vernon Pellet Stove (AE)
C. Top Vent Adapter Installation
3 to 3 inch Top Vent Adapter
3 to 6 inch Top Vent Offset Adapter
Installing the Top Vent Adapter
1. Put a layer of high temperature silicone on the
3 inch (76mm) exhaust outlet. Figure 18.1.
2. Slide the top vent adapter onto the rear exhaust
outlet and adjust the assembly to a vertical position
until the top of the fl ue outlet is centered and is in
a level position. Figure 18.1.
3. Drill 6 holes with #26 drill bit (provided) into the back
of the appliance using the outer shield as a pattern.
Figure 18.2.
4. Install the 6 mounting screws, 2 on the left and 4
on the right.
5. Drill 2 holes with #26 drill bit through the rear
exhaust outlet using the 2 holes already in the short
horizontal pipe in the top vent adapter as a guide.
Install the screws. Figure 18.1 and 18.2.
6. Install the vent pipe into the top vent adapter (be
sure to silicone all joints). To use an existing 6
inch (152mm) vent system, install the 3 to 6 in (76-
152mm) offset adapter before installing vent pipe.
7. To clean top vent adapter, open clean-out cover
and remove any debris build-up. Figure 18.2.
Silicone Rear
Exhaust Outlet
Figure 18.1
Page 18
3 in. to 6 in.
Offset Adapter
3 in. to 3 in. Top
Vent Adapter
Use holes on each
side as drilling
guide
Clean-Out Cover
Figure 18.2
D. Rear Vent and Rear Vent to Top Vent
Adapter Installation
Figure 18.3 - Rear Vent Adapter
Clean-Out Cover
Figure 18.4 - Rear to Top Vent Adapter - 90
1. Put a layer of high temperature silicone on the 3 inch
(76mm) exhaust outlet. Figure 18.1.
2. Slide the adapter onto the rear exhaust outlet and
adjust the assembly to the appropriate position.
3. Install the vent pipe into the adapter (be sure to
silicone all joints)
7034-106B
Use holes as drilling guide
Clean-Out Cover
December 22, 2006
R
o