Glass Replacement - Quadra-Fire SANTAFE-B1 Owner's Manual

R R
Santa Fe Pellet Stove
G. Glass Replacement
WARNING
• Glass is 5mm thick high temperature heat-
resistant ceramic glass.
• DO NOT REPLACE with any other material.
• Alternate material may shatter and cause
injury.
1. Open the face and remove door from the appliance by
lifting door off of hinge pin and lay on a flat surface face
down.
2. Using a screwdriver, tap the bottom of the rope retainer
rod to push it up out of the hole. The top end of the
rod will slide up. Swing the rod toward you from the
bottom and remove the rod. Repeat for other side.
. Remove old glass and replace with new glass.
4. Slide the retainer rod into the top hole first, and then
line up the bottom crimped end with the hole in the
door. The crimped end must be paralle with the glass
in order to insert it into place. Figure 35.1.
Rope Retainer
Glass
Figure 37.1
September 1, 2008
Rods
Slide this end
in first
Crimped end at
the bottom
Crimped end
must be
parallel with
the glass
7001-142D
R
Page 7