Section 7: Appliance Set-Up; Outside Air Kit - Quadra-Fire SANTAFE-B1 Owner's Manual

R R
Santa Fe Pellet Stove
7
Appliance Set-Up
A. Outside Air Kit Instructions
Parts Included in Kit: 1 piece of 2 inch x  foot flex hose,
2 hose clamps, 1 collar assembly, 1 termination cap assem-
bly, 1 trim ring, 12 screws. (Discard collar assembly and air
channel, collar assembly already on appliance).
Tools Needed: Phillips head screwdriver; wire cutters; hole
saw or jig saw.
1. Measure distance from floor to air vent opening in stove
and mark location on wall.
Use saw to cut opening in wall. Cut a 2-1/2 to  inch
(64-76mm) opening on inside wall and a  to -1/2 inch
(76-89mm) opening on outside of house.
2. Use hose clamp to secure flex pipe to collar assembly.
. Slide trim ring over flex pipe and run pipe through wall.
4. Attach hose to outside termination cap with second
hose clamp.
5. Secure termination cap to outside surface.
6. Secure trim ring to interior wall.
CAUTION
Never draw outside combustion air from:
• Wall, floor or ceiling cavity
• Enclosed space such as an attic or garage
September 1, 2008
Termination
Cap Assembly
Hose Clamp
Trim Ring
Flex Hose
Figure 17.4
7001-142D
Air Intake Channel
Hose Clamp
Collar Assembly
R
Page 17