Xerox Color 1000 Press System Administration Manual page 29

10. Select the tray where the stock is loaded and the desired output quantity to print.
11. Select the Start button.
Once the test prints are completed, the machine displays the following message:
12. Select either:
a) Done Adjusting: Select this if the output is properly adjusted.
This closes the current window and returns you to the Advanced Stock Setup
window.
b) Continue Adjusting: Select this if the output still contains too much paper curl,
print density, and needs further adjusting.
This allows you to make further adjustments to the paper curl correction and print
density options and run additional test prints. Repeat this step as required until
the desired output is achieved.
13. Select OK to close the Advanced Stock Setup window.
14. Select OK to save the changes to the stock and close the Stock Properties window.
15. Select Close to exit Manage Stock Library.
®
Xerox Color 800/1000 Press
System Administration Guide
Paper curl correction
4-7