Adjusting Automatic Tone Reproduction Curve; Adjusting Automatic Density Uniformity - Xerox Color 1000 Press System Administration Manual

Related Topics:

Adjusting Automatic Tone Reproduction Curve

Adjusting Automatic Density Uniformity

Adjusting Automatic Tone Reproduction Curve
1. Logon as Administrator.
2. Select the System Settings button.
3. Select the Full Width Array tab.
4. Select the Auto Adjust button for Automatic Tone Reproduction Curve Adjustment.
5. Select the appropriate halftone and then select the Next button.
6. Select the required options:
• ARC djustment Mode: either Simplified TRC (Faster) or High Accuracy TRC (Better
Quality)
• Tray
• Target Value (coated or uncoated)
• Color Mode
7. Select Start again.
The press will now run "Target" test prints and update the system appropriately.
8. Select one of the following:
• If the output prints are acceptable, select Accept Changes.
• If the output prints are NOT acceptable, select Start again to make the adjustment
prints.
Note
If acceptable output cannot be reached after numerous attempts, contact the
Customer Support Center.
9. Select Close.
10. Select OK from the System Settings window to return to the main UI window.
11. To exit the Administrator mode, select the Logoff button.
Related Topics:
Logging on as Administrator
Adjusting Automatic Density Uniformity
1. Logon as Administrator.
2. Select the System Settings button.
3. Select the Full Width Array tab.
®
Xerox Color 800/1000 Press
System Administration Guide
System Settings
5-27