Setting Up Tv1 To Operate In Ir (Default) - Dish Network DP512 User Manual

Setting Up TV1 to Operate in IR (default)

The following instructions describe how to set up TV1 to operate in IR only,
which is the default operation of this receiver from the factory.
1. Perform the following with an existing linked remote control:
a. Open the
TV1 UHF Pro Setup
remote control.
b. Select
Disable
c. Select
System Info
2. Perform the following with an IR remote that you intend to use to control
TV1:
a. Press the RECORD button on the remote control. The
should be highlighted on the screen.
b. Confirm that the
Remote Address
screen by pressing MENU-6-1-6 on the
from the
TV1 UHF Pro Setup
to open the
System Information
System Information
indicates .
IR
Setting Up TV1 to Operate in IR (default)
screen.
screen.
option
Done
screen displays the
Primary
Page 35