Table of Contents
Advertisement
For Example: Press MENU-6-1-3 on your remote control to
display the
•
Connections on the back of the receiver are in small capital letters.
For Example: S
•
Where this guide mentions nearby TV, it refers to any TV directly
connected to the receiver's TV1 outputs. A nearby TV receives the
menus and satellite programming from the receiver's TV1 outputs
and is connected using coaxial or RCA-type audio/video cables.
Also, a 4-pin analog S-Video cable can be used in conjunction with
stereo (RCA-type) audio cables.
•
Where this guide mentions remote control, it refers to either the
included IR remote control used when viewing a TV that is directly
connected to your receiver, or the optionally available IR/UHF Pro
remote control, which can be used to control the receiver through
walls, floors, or other obstructions. If a specific remote control must
be used, then this guide will refer directly to it.
Fixed Images
On some TVs, the presence of fixed images for extended
periods of time may cause them to be permanently imprinted
on the screen. Consult your TV's user guide for information
on whether this is a problem for your TV's display, what
operating/viewing restrictions apply to avoid this problem,
and any associated TV warranty coverage.
DISH Network Logo
Whenever the receiver's TV1 output(s) are turned off using the
remote control or front-panel POWER buttons, you will see
the DISH logo moving slowly on your TV screen. This feature
is included with your receiver to assure you that the
connections between your receiver and TV(s) are not lost.
Press the POWER or SELECT button on the remote control
to resume watching satellite TV programming.
: This logo is displayed using the TV1 video outputs, except for the
Note
CH 3–4 OUT. TV(s) connected using CH 3–4 OUT will not display this.
screen.
System Information
I
ATELLITE
N
Overview
Page 3
Hide quick links:
Advertisement
Table of Contents
