Optimize Your Remote Control(S); Change The Address - Dish Network DP512 User Manual

Chapter 2
Receiver Description and Installation

Optimize Your Remote Control(s)

Change the Address

Confirming the Remote Control Address
Page 32
TV distribution equipment devices may include coax panels, amplifiers or super
home nodes, and are available through many consumer-electronics companies.
When you receive your system, the remote control(s) and the receiver have both
been set to communicate on address 1. However, because UHF radio signals can
travel long distances and go through walls, a neighbor's UHF Pro remote could
control your receiver by mistake if they are set on the same address.
: You can use this procedure to change the
Note
the IR remote control on a nearby TV, if necessary. However, if you are using an
IR/UHF Pro remote to control
the UHF Pro remote address.
To handle this situation, you can change the remote address on a UHF Pro
remote control and the receiver as follows:
1. Make sure you power on the TV and can view the screen.
2. Press the front panel SYSTEM INFO button to display the
screen.
The screen shows the
System Info
Write down this address:
3. Press and hold the SAT button on the UHF Pro remote control for
about three seconds, until all of the mode buttons light up, and
then release the SAT button.
4. Use the remote control NUMBER PAD buttons to enter any number
between 1 and 16, but not the one that you just wrote down in step 2.
Write down the number you entered:
5. Press the POUND (#) button. If you entered the address correctly,
then the SAT mode button will flash three times.
6. Press the RECORD button on the UHF Pro remote control.
7. Make sure the
Pirmary Remote Address
screen is the same as the one that you entered in step
System Info
4. If it is not the same, the remote is not controlling the receiver.
8. Press the SELECT button to close the
screen.
Information
1. Press and hold the SAT mode button for three seconds, until all of
the mode buttons light up, and then release the SAT button.
2. Press the POUND (#) button twice. The SAT mode button will
flash the same number of times as the address number (for
example, three flashes of the mode button means address 3).
Primary Remote Address
, use the instructions on page 34 to change
TV1
Primary Remote Address
you see now on the
Important System
for
System Info
.