Table of Contents
Advertisement
Chapter 2
Receiver Description and Installation
Connecting the Receiver to Your Nearby TV
Coaxial Cable Connections
Page 24
Attention
working very well from far away, you may be experiencing
interference from objects near your receiver. To improve the
remote control's range, try any or all of the following:
• Place the receiver higher than all of the other equipment in your
entertainment center. Place nothing above the entertainment
center.
• Provide space behind and above the receiver so that the UHF
antenna can be installed and positioned straight up. If this is not
possible, you can tilt the UHF antenna at about a 30° angle.
• Place the UHF antenna outside the entertainment center by
using a coaxial cable to connect the antenna to the receiver.
• Try moving the receiver and/or antenna to another location.
• Move all nearby over-the-air antennas away from the UHF
remote antenna. Do not place any antennas on your receiver.
• Attach a UHF-signal attenuator as described on page 33.
This section describes how to connect receiver
TV. The easiest way to connect the receiver to the TV is using coaxial cable
connections, but you may also use the composite
1. Connect a coaxial cable from the
TV's tuner input port.
2. Place the white
CH 3-4
the receiver (see the picture in the margin on the next page).
3. Plug in the power cord for the receiver.
: If your optional DISH UHF Pro remote control isn't
TV 1
output on the receiver to a nearby
CH 3-4
sticker on the cable near where the cable connects to
output port(s) to a nearby
or
outputs.
RCA
S-Video
Hide quick links:
Advertisement
Table of Contents
