Fujitsu PRIMERGY TX150 S2 Manual page 153

Removal/installation routines
Ê Route the fibre channel optical waveguide cable on the articulated cable
carrier as shown in the figure and secure them with cable ties (1).
Please make sure that the fibre channel optical waveguide cable
!
(protected as described) is routed in such a way on the articulated cable
carrier that in the extended as well as in the folded condition of the carrier
no damages can occur.
Mounting in 3rd-Party racks
For mounting the server in a 3rd-Party rack the following parts from the rack
mounting kit S26361-F2734-E/L31 are necessary:
– two telescopic rails (assembled)
– four assembly brackets (VL; VR; HL; HR)
– (possibly) eight plug washers
– (possibly) protective hose for fibre channel optical waveguide cable
Ê Consult the original manual of the 3rd-Party rack for information about
mechanical installation in the rack and/or environmental considerations.
When installing the server in a 3rd-Party rack it is essential that air
!
flow is maintained from the front of the rack to the rear of the rack to
properly cool the server.
U41057-J19-Z146-1-76
Fit assembly kit and rack-mount the server
1
July 2004 02 TX150S2 153
– –