Table of Contents
Advertisement
Removal/installation routines
Ê Fix the locking rail with four screws (1) on the rear side of the server.
Ê Fix the power supply cage with three screws (2).
Ê Connect all boards and devices to the new power supply. For the cabling see
page
02-TX150S2-59.
Ê Reinstall the air duct.
Ê Insert the power supply module.
The redundant power supply module automatically adjusts to the
i
proper voltage range.
Ê Install the dummy module.
Ê Close the server.
Ê Mount the anti-tilt bracket (see
Ê Connect the power supply module to a grounded power outlet with the power
cable supplied.
You will find the description of the indicators of the power supply module on
page
02-TX150S2-36.
After installing the redundant power supply the SDR (sensor data record)
!
data base must be updated. For this sequence you need the BIOS flash
diskette prepared before. This diskette contains the newest BIOS
version, the BMC firmware and the SDR data.
U41057-J19-Z146-1-76
page
02-TX150S2-20).
July 2004
Power supply
1
2
02
TX150S2
129
–
–
Advertisement
Table of Contents
