Fujitsu PRIMERGY TX150 S2 Manual page 137

Removal/installation routines
Ê Remove the two upper rubber feet (arrows) on the left side.
Ê Remove the three screws (circles) and take out the rail with the two lower
rubber feet.
The drive cage is designed to make it possible to remove easily the accessible
drives and the operating panel module and remount them with being turned to
the left by 90°.
Ê Remove the 5.25" drives from the drive cage (see
Ê If needed remove the dummy covers.
Ê Pull the operating panel module out of its bay as far as it is possible to unplug
the flat ribbon cable and the USB cable from the operating panel board.
Unplug both cables.
Ê Remove the operating panel module.
U41057-J19-Z146-1-76
Conversion of the housing model
July 2004
page 02-TX150S2-94).
02 TX150S2
–
137
–