Table of Contents
Advertisement
Removal/installation routines
The assemble telescopic rail and assembly bracket (HL) will be secured on the
front left support upright and on the support angle.
Ê Using the supplied Allen key (No. 5) secure the end of the telescopic rail
without assembly bracket with two screws M5 (1) in the rack at the front left
support upright.
Please note that the guide nubs of the telescopic rail next to the spring nuts
must fit into the holes in the support upright.
Ê Secure the end of the telescopic rail assembled with the bracket (HL) with
two screws M4 (2) on the support angle in the rack.
Note with the fact that the two plug washers are inserted in the appropriate
openings of the support angle.
Ê Adjust if necessary the length of the telescopic rail by using the oblong holes
of the assembly bracket (HL).
U41057-J19-Z146-1-76
Fit assembly kit and rack-mount the server
1
2x M5x8
July 2004
2x M4x8
2
02
TX150S2
147
–
–
Advertisement
Table of Contents
