Table of Contents
Advertisement
Removal/installation routines
Installing the system board
Ê Insert the system board by holding it at a slight angle and sliding the
connectors into the connector panel.
There will be some resistance.
Make sure that the two light emitting diodes (positioned beneath
!
keyboard/mouse socket) are not damaged.
Ê Adjust the system board with the two centre bolts (1+2 in graphic on page
before).
Make sure that the guide rings engage properly in the drill holes of
!
the system board. After this it is no longer possible to push the system
board sidewards.
Ê Fasten the system board with the 11 screws.
Ê Reconnect the cables to their original connectors.
For the cabling see
i
Ê Reinstall the processor and the processor heat sink.
Ê Reinstall the system fan.
Ê Reinstall the air duct.
Ê Reinsert the controllers to their slots.
Ê Reinsert the memory modules into their memory banks.
After installing the new system board, it is absolutely necessary to
!
update the BIOS to ensure proper operation.
U41057-J19-Z146-1-76
page
02-TX150S2-59.
July 2004
System board
02
TX150S2
119
–
–
Advertisement
Table of Contents
