Table of Contents
Advertisement
Replacing the IDTEMP combo
Ê Push the holder in direction of the arrow.
Ê Take out the holder carefully.
Ê Remove the green plastic part from the connector on the IDTEMP combo.
Ê Disconnect the I
Notice the leading of the cable.
!
Ê Pull the IDTEMP combo out of its holder.
Installing is done in reverse order.
02
TX150S2
132
–
–
The green plastic part is the colored marking
of a 'touch point'.
2
C bus cable from the connector.
July 2004
Removal/installation routines
U41057-J19-Z146-1-76
Advertisement
Table of Contents
