Replacing intrusion detection switches
Ê Remove both screws of the second intrusion detection switch which is
mounted on the front cover (1).
Ê Reach for the intrusion detection switch through the left side opening under
the SCSI hard disk cage and pull the intrusion detection switch backwards
through the recess in the front cover (2).
Ê Disconnect the end of the intrusion detection switch cable from the intrusion
connector on the system board (see
Installation of the new intrusion detection switches is to be performed in reverse
order.
02
TX150S2
134
–
–
Removal/installation routines
1
2
1
page
02-TX150S2-43).
July 2004
1
U41057-J19-Z146-1-76