Table of Contents
Advertisement
3.4
Performing a Setup
An Engineer would normally perform this task for you.
Prerequisite 1
All types of Customer Document are available.
Prerequisite 2
A measuring ruler. This may be graduated in Metric or
Imperial units. Note: 1 inch = 25.4 mm.
Move to each of the Menu's shown below and for each Parameter check or set a
new Value.
3.4.1
COM Menu
This menu is available on Serial Printers only. It is used when changing the
Communication Settings.
The Baud Rate values are:
19200, 9600, 4800, 2400 and 1200 Baud
Further Parameters and Values are:
Length (bits)
Value
7
Value
8
Value
3.4.2
IBM Menu
The standard IBM Proprinter III parameters are used where:
The Country values are:
USA
-
Multi (Latin)
-
Note:
A Code Page is downloaded from the Host Computer. At Power
ON the option set will be used unless overridden by a download.
Setup
Parameter
Stop Bits (number)
1
2
Code Page 437 (Factory Default Setting)
Code Page 850
Parity
Flow Control
Even
RTS-CTS
Odd
XON-XOFF
None
3-10
Advertisement
Table of Contents
