Table of Contents
Advertisement
6.4.1
Recommendations and Restrictions
Transparent documents or documents containing transparent areas cannot be
used. Reflective ink surfaces (i.e. silver, gold) do not cause problems with the
edge detection system.
Dark areas at the top of a form, close to the Left and Right Margins, i.e. Logo's
and Letterheads will cause problems unless the TOP OFFSET in SETUP is
correctly set.
Documents with staples, paper clips, holes or perforations are not permitted.
Multi-ply forms of different lengths can be handled only if they are aligned at
the top. The shortest form must have a minimum length of 7.3" (185 mm) and
the software must eject the form at the rear of the printer.
Multi-ply forms can consist of up to 3 copies plus the original.
Multi-ply forms with carbon sheets are not supported.
The single part sheet and the top sheet of a multi-ply form should be either white
or a light color for maximum print contrast.
When preprinted lines are required, the preprint must be as thin and fine as
possible to produce legible results.
6.4.2
Passbook Thickness
The maximum thickness of a passbook shall not exceed 0.08" (2.0 mm) when the
print page is opened. The difference between the maximum and the minimum
thickness at the centerfold shall not exceed 0.05" (1.4 mm) except for an end sheet
(vertical seam passbook only).
Specifications
6-7
Advertisement
Table of Contents
