Usb Cloning Procedures - LG 55WV70 Setup Manual

(Continued from previous page)
• Otherwise, ensure the Target TV is in Pass-through Mode, and then
continue with step 2.
2. Use the Installer Remote to access the Target TV Installer Menu (see
"Accessing the Installer Menu" on page 19 for further information). Set
Installer Menu item 117 FACT DEFAULT to 1, and press OK. When the
value changes back to 0, press OK again to exit the Installer Menu.
Note: This step restores factory default settings on the TV, which will in turn
re-activate the EZ-Manager Wizard. Either use the wizard or the LG Smart
Install utility to finish this process, or exit the wizard (see step 1) and then
continue with step 3.
3. Tune/set the TV to an analog or digital channel or Aux input (ideally the same
source tuned for 2-5-5 + MENU Mode during the Master TV Setup procedure).
4. Insert the USB memory device with the .tll file into the Target TV USB IN
port.
5. Press MENU SETTINGS on the Installer Remote to display the TV setup
menus. Use the arrow navigation keys to select/highlight the Option menu
icon, and then press the number "7" key a total of seven times to display the
USB Download Menu.
6. Use the Up/Down arrow keys to select Teach To TV (TLL), and then press
OK.
7. Use the Up/Down arrow keys to select the Master TV Setup you want to
install, and then press OK. Note: Filenames identify the TV and the TLL
version (see example at right).
Teaching status will be shown on a progress bar in a new window. When the
Teaching process is complete, the USB Download menu will reappear on
the screen.
8. When Teaching is done, press
Download Menu, remove the USB memory device from the Target TV, and
turn OFF the TV.
9. After a few seconds, turn ON the TV, and verify that the Master TV Setup is
now resident on the Target TV.
Note: When you turn it back ON, the TV will tune according to the setting of
Installer Menu item 004 STRT CHANNEL (Start Channel). If a Start Channel is
specified, the TV will tune to that channel; otherwise, the TV will return to the
last channel tuned.
206-4231
on the Installer Remote to exit the USB
USB Cloning Procedures (Cont.)
USB Download Menu
Upgrade TV Software
Upgrade PTC Software
Teach To TV (TLL)
Teach To TV (TLX)
Previous
Teach To TV (TLL)
xxLP62xH-UA00001.TLL
Previous
Teach To TV
UPDATING...
50%
Do not remove the USB from the port!
Do not unplug!
OK
OK
37