Adjusting The Projector's Elevator - InFocus IN5132 User Manual

Operating

Adjusting the projector's elevator

When the projector surface is slightly uneven to the
left or right, use the elevator feet to place the projector
horizontally.
You can also tilt the projector using the feet to project at
an appropriate angle to the screen, elevating the front
side of the projector up to 9 degrees.
This projector has 2 elevator feet and 2 elevator buttons.
To adjust an elevator foot, you must push the elevator
button which is on the same side as it.
1.
Holding the projector, push the elevator buttons to
loosen the elevator feet.
2.
Position the front side of the projector to the desired
height.
3.
Release the elevator buttons in order to lock the
elevator feet.
4.
After verifying that the elevator feet are locked, put
the projector down gently.
5.
If necessary, the elevator feet can be manually
twisted to make more precise adjustments. Hold the
projector when twisting the feet.
CAUTION
projector, since the projector may fall down.
►Do not tilt the front of the projector beyond 9 degrees. A projector tilt
exceeding this restriction can cause a projector malfunction and shorten the
lifetime of the lamp or the projector itself. IN5142, IN5144, IN5144a and IN5145
only: It is possible to install the projector in any direction with specified mounting
accessories. Contact your dealer about such a situation.
28
►Do not handle the elevator buttons without holding the
To loose an
elevator foot,
push the elevator
button on the
same side as it.
To finely
adjust, twist
the foot.