Connecting Power Supply - InFocus IN5132 User Manual

Fastening the adapter cover
When using the USB wireless adapter, be sure
to connect the adapter to the USB TYPE A
port furthest away from the LAN port and use
the supplied adapter cover.
Loosen the screw (marked with triangle) on
1.
the bottom left of the USB TYPE A ports.
2. Insert the cover tab into the hole at the upper right of the
USB TYPE A ports in the direction of the arrow.
Align the screw holes on the projector and the cover. Then
3.
insert the screw removed from the projector into the hole and
tighten the screw.
WARNING
pets. Do not put any parts into the mouth.
possible burns disconnect the projector power cord for 10
minutes before touching the adapter.

Connecting power supply

1.
Plug the power cord into the AC IN (AC inlet)
connector of the projector.
2.
couple of seconds after the power supply connection,
the POWER indicator will become a steady orange.
Please remember that when the DIRECT POWER ON
function is activated, the power supply connection will
make the projector turn on.
WARNING
unit is attached to it.
Please use extra caution when connecting the power cord, as an incorrect or
Only use the power cord that came with the projector. If it is damaged, consult
your dealer to get a new one. Never modify the power cord.
Only plug the power cord into an outlet whose voltage is matched to the power
cord. The power outlet should be close to the projector and easily accessible.
Remove the power cord for complete separation.
shock or other accidents.
of the building using an appropriate power cord (bundled).
NOTICE
to-phase voltage of 220 to 240 V.
8
1
Power
cord
2
Tab
3
AC IN