Using The Automatic Adjustment Feature; Adjusting The Position - InFocus IN5132 User Manual

Using the automatic adjustment feature

Press the AUTO button on the remote control.
1.
Pressing this button performs the following.
 For a computer signal
The vertical position, the horizontal position and the
horizontal phase will be automatically adjusted.
Make sure the application window is set to its
maximum size before to attempting to use this feature. A dark picture may still be
inadjusted correctly. Use a bright picture when adjusting.
 For a video signal and s-video signal
The video format best suited for the respective input signal will be selected
automatically. This function is only available when the AUTO is selected for
the VIDEO FORMAT item in the INPUT menu (51). The vertical position and
horizontal position will be automatically set to the default.
 For a component video signal
The vertical position and horizontal position will be automatically set to the default.
The horizontal phase will be automatically adjusted.
NOTE
• The automatic adjustment operation requires approx. 10 seconds, and
may not operate correctly with some inputs.
• When this function is performed for a video signal, certain extra items such as a
line may appear outside the picture.
• When this function is performed for a computer signal, a black frame may be
displayed on the edge of the screen, depending on the computer model.
• The items adjusted by this function may vary when FINE or DISABLE is selected for
the AUTO ADJUST item of the SERVICE item in the OPTION menu (69).

Adjusting the position

Press the POSITION button on the remote control when no menu is
1.
indicated. The "POSITION" indication will appear on the screen.
2.
Use the ▲/▼/◄/► cursor buttons to adjust the picture
position.
When you want to reset the operation, press RESET
button on the remote control during the operation.
To complete this operation, press POSITION button again. Even if you do not do
anything, the dialog will automatically disappear after a few seconds.
NOTE
• When this function is performed on a video signal or an s-video signal,
certain extra items such as a line may appear outside of the picture.
• When this function is performed on a video signal or s-video signal, the range of
this adjustment depends on OVER SCAN in the IMAGE menu (48) setting. It is
not possible to adjust this function when OVER SCAN is set to 10.
• If the POSITION button is pressed when a menu is indicated on screen, the
displayed picture does not move its position but the menu does.
• This function is unavailable for a signal from the LAN, USB TYPE A / B or HDMI 1 / 2 port.
Operating
AUTO
button
POSITION
button
31